operate current造句

• It is well established that facet damage is caused by the optical flux density at the laser facet and that it is not a function of the operating current .
  业已明确肯定，端面损伤是由激光器端面的光流密度引起的，并且不是工作电流的函数。
• Operating voltage : 3 5 vdc operating current : 25 150 ma
  Add :西安高新区科技5路22号
• Continuous operating current
  连续工作电流
• Ratio of peak lamp current to rms or average lamp operating current
  灯电流峰值与rms （均方根值）或平均工作电流的比值。
• Only licensed banks may operate current or savings accounts . they may also accept deposits of any size and any maturity from the public
  只有持牌银行才可经营往来户口或储蓄户口业务，并可接受公众任何数额及期限的存款。
• Only licensed banks may conduct full banking services , including operating current and savings accounts and accepting deposits of any size and maturity
  只有持牌银行可从事全面的银行业务，包括经营往来与储蓄帐户业务，以及接受任何数额与期限的存款。
• Working voltage : 5 24v operating current : 10ma 24v static 0 . 6ma output signal connection : examines outputs 1 second low level to a vibration sensitivity : continuously may move outlook size : 50 30 20mm
  工作电流： 10ma24v静态0 . 6ma输出信号接口：检测到一次振动输出1秒低电平灵敏度：连续可调
• In hong kong , only licensed banks may operate current and savings accounts , and accept deposits of any size and maturity from the public and pay or collect cheques drawn by or paid in by customers
  在本港只有持牌银行才可经营往来及储蓄户口业务，并接受公众任何数额与期限的存款，以及支付或接受客户签发或存入的支票。
• The simulation results show that to start the oscillation , the length of the resonance cavity must be well matched with the radial span of the cavity ; mismatch of them will greatly affect the microwave development ; the output power of the microwave in rtto is affected by the microwave mode obviously . under the same conditions , the output power for temooi mode is the highest , and its start and saturation time of oscillation are the shortest . the results also show that the output power will decrease with the increase of the size of the extract window ; the operating state of rtto has great close relationship with the operating current , and there exists an optimum current value
  结果表明，束电压一定时，谐振腔腔长和径向间距必须良好匹配微波才能起振，匹配不佳会极大地影响微波产生；微波模式对微波产生功率影响很大，同等条件下， tem _ ( 001 )模式的微波功率最高，起振时间和饱和时间最短；微波输出功率随提取口的增大而减小； rtto工作状态与工作电流的大小关系密切，存在一个最佳工作电流值。
• In a room containing a bath or shower , the provision of socket outlets should comply with iec 60364 - 7 - 701 ( to be installed at location 0 . 6 m away from shower basin or bath tub ) and the socket outlets should be protected by a residual current protective device ( rcd ) with a residual operating current not exceeding 30ma
  设有浴缸或花洒的浴室内，插座应符合国际标准iec60364 - 7 - 701的规定（包括安装的位置距离浴盆或浴缸0 . 6米以外） ，并由馀差启动电流不超过30毫安的电流式漏电断路器加以保护。
• The third one , we calculated the local facet temperature theoretically and experimentally when ld are operated , the former , we used the henry ' s model , however , the latter , we chose the photoluminescence and raman spectra , finally , we found that accuracy of pl is better than that of raman spectra , however , theoretical results is higher than trial results , but theoretical results accorded with pl when operating current increase . the fourth , electric derivative testing techinque at the constant current ( 500ma ) and temperarure ( 40c ) . we study the reliability of ld , and analyzed the reasons , we measured more than the ingaasp high power semiconductor lasers with electric derivative technique , and analyzed the relation between the electric derivative parameters , m , b , h and reliability of devices
  分别从理论上和实验上计算分析了激光器在工作时腔面的温度分布，理论上采用的是henry模型，实验上通过光致发光和拉曼光谱法测试了激光器在工作时的腔面温度分布；结果表明光致发光法测量的较为准确，拉曼光谱法测量的值偏大，由于我们对理论模型做了一定的近似，理论结果偏大，但理论值在大注入时和光致发光法符合的较好，由此可见光致发光法对研究腔面的温度有更大的优越性。
• The traditional bandgap reference circuit was improved in the design , which includes the applying of self - bias structure and cascode structure , output of the opamp was used as self - bias voltage , saving bias circuit , and then it was helpful to get low power consumption . through using poly resistance of high value with low temperature coefficient , we reduced the influnce to circuit , if power supply did not change , we must decrease operating current to decrease power consumption , and increasing value of resistor could decrease the operating current efficiently . poly resistance of high value had large value of squared resistor , so we could save layout area
  对传统带隙基准电路进行了改进设计,采用自偏置结构和镜像电流镜结构,利用运放的输出电压作为运放的偏置电压,节省了偏置电路,降低了功耗;使用低温度系数的多晶硅高值电阻,降低了电阻温漂对电路的影响;在电源电压不变的情况下,为了减小功耗就必须减小工作电流,而增大电阻的阻值能有效地减小工作电流,多晶硅高值电阻的方块电阻很大,可以节省版图面积。